Fujitsu Lifebook E360 - Page 75

Using Your LifeBook E Series
LifeBook E Series from Fujitsu
65
4. When the Fujitsu Logo appears on your
screen press F8 immediately, before the
Windows 98 banner appears on the screen.
5. Select 6. Safe mode command prompt only,
then press Enter.
6. At the c:\> prompt, type cd fujitsu,
Press the Enter key.
7. The screen will display the size of the space
currently allocated to the Save-to-Disk
function and other parameters about the
space and the hard drive.
To remove all space allocation for the Save-to-
Disk function, do the following:
1. Click on Start.
2. Click on Shut Down.
3. From the Shut Down menu select the
restart option.
4. When the Fujitsu Logo appears on your
screen press F8 immediately, before the
Windows 98 banner appears on the screen.
5. Select 6. Safe mode command prompt only,
then press Enter.
6. At the c:\> prompt, type cd fujitsu,
then press Enter.
7. Type PHDISK /DELETE /FILE
Press the Enter key.
The utility will remove the space allocation for
the Save-to-Disk function and free that space
for other use.
If you have just installed a new Memory
Upgrade Module, or have a read or write error
while going into Save-to-Disk mode, you will
need to reset your Save-to-Disk parameters.
Three
To reset the Save-to Disk parameters, use the
procedure below.
Resetting the Save-to-Disk Parameters:
1. Click on Start.
2. Click on Shut Down.
3. From the Shut Down menu select the
restart option.
4. When the Fujitsu Logo appears on your
screen press F8 immediately, before the
Windows 98 banner appears on the screen.
5. Select 6. Safe mode command prompt only,
then press Enter.
6. At the c:\> prompt, type cd fujitsu,
then press Enter.