Working with the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the mains adap ter cable to the D C
jack (DC IN) of the Port Replicator (1).
► Connect the power cable to the
mains a d apter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardw are profile for the "Docked" mode. In this profile, for example, the setting is
saved a s to which monitor was last used for output. Th is profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/O
FF switch on the port
replicator to
switch the notebook on.
The power-on indicator of the Port
Replicator lights up.
Switchi
ng off notebook via Port Replicator
► Close all applications and shut down your operating system (please refer
to the m anual for the operating system).
If the notebook cannot be shut do wn properly, press the ON/OFF button
on the Port Replicator for approx. four seconds. The notebook will switch
off. Any unsa ved data may however be lost.
46 Fujitsu Tech nology Solutions
To Next Page
Loading...
