Working with the notebook
Adjusting the stylus
Operating system Menu
Windows 8.1 Under Windows 8.1 Desktop - Control Panel - Hardware and Sound - Pen and
Touch Input you can ma ke various settings for the stylus (assignment
and function of the s tylus button).
Calibrating the st ylus
If Windows 8 .1 is installed on your Tablet PC, your Tablet PC is already calibrated at initial setup.
If a different opera ting system is installed on your Tablet PC, you must calibrate it with the
stylus before first use, so that it recognizes the stylus as accura tely as possible.
You should also always repeat the calibration if the co-ordination between the
stylus and the c ursor movement deteriorates.
Operating system Menu
Windows 8.1 Desktop
To calibrate, run the Hardware and Sound / Tablet PC Settings function in the
Control Panel. You need to ca librate both portrait and landscape formats.
Replacing the stylus tip
With use, the stylus tip may become worn or may pick up foreign particles tha t can scratch the screen.
A damaged or worn tip may not move freely, causing unpredictable results when using the stylus.
If your stylus exhibits these problems, you s hould replace the stylus tip. To
do this, use the supplied tool (1).
1
► To remo ve the tip, position it in the gap
between the two ends of the tool supplied.
► Pinch the two ends of the sup plied tool
together so that the tip is firmly clasped,
then pull it from the barrel.
► Replace the tip with one of the new tips
that were supplied with your stylus. Insert
the flat end of the tip into the barrel
and exerting gentle pressure, push it
in until it is firmly in place.
If the tip is worn or damaged, discard it.
40 Fujitsu
To Next Page
Loading...
