Troubleshooting and tips
User and/or supervisor SmartCard lost
Cause
Troubleshooting
User and/or supervisor SmartCard lost ► If you have lost your User SmartCard, you
can continue working with the Supervisor
SmartCard and initialise a new User
SmartCard or deactivate the Syste m Lock
function.
► If you have lost the Supervisor SmartCard,
you can continue working, but you no longer
have all your rights and ca n no longer
initialise a Supervisor SmartCard.
► If you have lost both S martCa rds, you can
no longer boot your system. Please contact
our Service Desk. You must provide pro of of
ownership for the device. Then the S e rvice
Deskwillreferyoutoourservicepartner,
who will unlock your device (for a charge).
Acoustic warnings
Acousticerrorm
essages
Errors
Cause
Troubleshooting
A be e p sounds every few seconds.
The battery is almost flat.
► Ch arge the battery.
Error messages on the screen
Errormessages onthescr eenErrormessage:
This section
describes the error messages generated by the BIOS Set up. Error messages displayed
by the opera
ting system or programmes are described in the relevant documentation.
If the error
message appears repeatedly, despite troubleshooting measures, please
contact th
e place of purchase or our customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is flat.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Pre ss the function key
F2
to access the
BIOS Setup.
► In the BIOS Setup , select the Exit menu.
► Select the entry Loa d Setup Defaults.
► Select OK and press the Enter key.
96 Fujitsu
To Next Page
Loading...
