Security functions
Carrying out administrator functions
If you have an internal SmartCard reader, you can switch on the device by inserting the SmartCard.
If you switch on the device with the ON/OFF switch then the following message appears:
SystemLock
Insert a SmartCard.
Administrator functions
► Insert the Admin SmartCard. The following m essage will be displayed:
EnteryourPIN:
Yo u can now select:
F2=Setup, F3=Change PIN, F4=Administration
► Press the
F4
function key. The following m essage w ill be displayed:
Enter the PUK:
► If you have entered the PUK correctly, you receive the following message:
PUK OK.
Initialize another SmartCard or p ress ESC to abo rt?
F5=User, F6=SuperUser, F7=Admin, F8=Service, F9=Unblock SmartCard, F10=Uninstall
F5
: Normal User SmartCard ("System" access rights):
Only allows system start-up, doe s not a llow changes in BIOS Set up.
F6
: Extended User SmartCard ("System and Setup" access rights):
Allows system start-up and changes in BIO S Setup.
F7
: Admin SmartCard ("Admin" access rights):
Allows genera tion of further Admin SmartCards.
F8
: Service SmartCard ("Service" access rights):
Only allows changes in B IO S Setup.
F9
: Re-activate a blocked User SmartCard.
Enables a new user PIN entry.
F10
: Uninstalls SystemLock.
Additional SmartCards should be produced either as Normal User SmartC ards
("System") or as Extended User SmartCards ("System and Setup"). These
then have restricted access to the device.
► Press the desired function key. The f ollowing message will be displayed:
Remove the SmartCard.
► Remove the Admin SmartCard.
Insert a SmartCard.
Keep the Admin SmartCard in a safe place and protect it from unauthorised access.
Fujitsu 75
To Next Page
Loading...
