Fujitsu M3093GX User Manual

● 7 - 17
16 Adjust FB Erasing Edges
1. Press “Next” or “Previous” and let the scanner display Screen 40.
Screen 40
2. At Screen 40, press or to select “Yes” and press . Then the scanner displays Screen 41.
Screen 41
3. At Screen 41, select “Yes” to return the settings to the factory default or select “No” to make new
settings (as shown below). Then press . The scanner displays Screen 42.
Screen 42
4. At Screen 42, press or to change the top setting. The value changes in 1 mm units. Then press
to activate the setting. The scanner displays Screen 43.
Screen 43
5. At Screen 43, press or to change the bottom setting. With (+:Up), the area is set upward from
the bottom edge of the image. With (–:Down), the area is set downward from the bottom edge of the
image. The value changes in 1 mm units. Then press to activate the setting. The scanner
displays Screen 44.
Screen 44
6. At Screen 44, press or to change the left setting. The value changes in 1 mm units. Then press
to activate the setting. The scanner displays Screen 45.
Screen 45
C
hange
?
No/ Yes
!
18 FB
E
dgeERS
No/ Yes
!
18- 1
D
e
fault?
T
op= 0
m
m
!
1 8- 2
F
B
T op
B
tm= 0
m
m
(+:Up)
!
1 8- 3
F
B
B ot t m
L
ef t =
0
m
m
!
1 8- 4
F
B
L ef t
R
ight=
0
mm
!
18- 5
F
B
Ri g ht

Fujitsu M3093GX Specifications

General

Brand	Fujitsu
Model	M3093GX
Category	Scanner
Language	English