Fujitsu Primergy RX300 S3 - 4 Replacement Routines; Preparation; Opening the Server; Replacing the Operating Panel

RX300 S3 Service Supplement 17
4 Replacement routines
V CAUTION!
Observe the safety instructions in the chapter “Safety notes” on page 11.
4.1 Preparation
I You will find a detailed description of ’Opening the server’ and ’Removing
the front cover’ in the Options Guide PRIMERGY RX300 S3.
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
switch.
Ê Pull all power connectors out of the power outlets.
4.1.1 Opening the server
Ê Loosen the two knurled screws and pull the server as far as possible out of
the rack.
Depending on how accessible the server is in the rack cabinet, it can make
sense to remove it from the cabinet. You will find a detailed description in the
Options Guide or the Operating Manual.
Ê Push the two locking buttons and remove the cover.
Ê Slide the cover to the rear side and remove it.
4.2 Replacing the operating panel
Ê Open the server as described in the section “Opening the server” on
page 17.