46 Service Supplement RX300 S3
Replacing the system board Replacement routines
© cognitas. Gesellschft für Technik-Dokumentation mbH 2007 Pfad: P:\RX300S3\RX300_S3_SS_bearbMoni\RX300S3_2x6HDD_ss_en\rx300s3-ss-e.k04
4.10 Replacing the system board
Ê Open the server as described in the section “Preparation” on page 17.
Ê Remove the fan box, processor heat sinks, processors, and PCI controllers.
If a riser card is installed, it has to be removed too.
I Information to this item you will find in the ’PRIMERGY RX300 S3
Options Guide’.
Figure 38: Removing the cables from the system board
Ê Remove the cables from the system board.
To Next Page
Loading...
