RX300 S3 Service Supplement 45
Replacement routines Replacing the IDTemp Combo
Figure 37: Routing the SMB cable for 2,5“ HDDs
Ê Connect the SMB cable on the expander board.
Ê Route the SMB Kabel as shown in the figure. Fix it under the cable clamp.
The Installation takes place in reverse order.
Information about the cabling you will find in the „appendix“ of the Options Guide
PRIMERGY RX300 S3.
I After installing the new IDTemp Combo, it is necessary to program the
ChassisID prom with the help of the "ChassisIDProm Tool" to enable
ServerView and ServerStart to identify the system. You will find the tool
on the ServerSupport CD and/or it can be downloaded from the Fujitsu
Siemens Computers Service and Support page (URL:
http://extranet.fujitsu-siemens.com/service/information/intelservers/tools).
To Next Page
Loading...
