RX300 S3 Service Supplement 25
Replacement routines Replacing the hot-plug PCI board
Ê Push the backplane in the direction of the arrow and out of the recesses.
Ê Remove the backplane.
The installation takes place in reverse order.
Information about the cabling you will find the „appendix“ of the Options Guide
PRIMERGY RX300 S3.
4.5 Replacing the hot-plug PCI board
4.5.1 Removing a defective hot-plug PCI board
Ê Open the server as described in the section “Preparation” on page 17.
Ê Remove the controllers from both hot-plug PCI slots.
Figure 12: Removing hot-plug cable
Ê Remove the cable from the connector on hot-plug Board.
To Next Page
Loading...
