RX300 S3 Service Supplement 29
Replacement routines Replacing the SAS backplane/expander board
4.6 Replacing the SAS backplane/expander
board
Ê Open the server as described in the section “Opening the server” on
page 17.
Ê Remove the fan box.
I You will find a detailed description of the removing of the fan box in
section “Fan box” on page 38.
Removing the SAS backplane/expander board
Figure 17: Removing cables from the SAS backplane
I In both varians the remove takes place in the same way.
Ê Remove all cables from backplane.
To Next Page
Loading...
