44 Service Supplement RX300 S3
Replacing the IDTemp Combo Replacement routines
© cognitas. Gesellschft für Technik-Dokumentation mbH 2007 Pfad: P:\RX300S3\RX300_S3_SS_bearbMoni\RX300S3_2x6HDD_ss_en\rx300s3-ss-e.k04
Figure 35: Removing the connector clamp
Ê Remove the connector clamp.
Ê Insert the IDTemp Combo into the holder.
I The routing of the SMB cable is different in the two variants for either 3.5“
HDDs or 2.5“ HDDs.
Variant 3.5“ hard disk drives
Figure 36: Routing the SMB cable for 3.5“ HDDs
Ê Connect the SMB cable on the SAS backplane.
Ê Route the SMB Kabel as shown in the figure. Fix it under the cable clamp.
To Next Page
Loading...
