22 Service Supplement RX300 S3
Replacing USB module Replacement routines
© cognitas. Gesellschft für Technik-Dokumentation mbH 2007 Pfad: P:\RX300S3\RX300_S3_SS_bearbMoni\RX300S3_2x6HDD_ss_en\rx300s3-ss-e.k04
Figure 8: Remove the USB panel board.
Ê Push the board to front until the the recesses of the panel board are aligned
with the recesses of the USB modul frame.
Ê Remove the board.
The installation takes place in reverse order.
I Do not forget to replace the insulation foil and be sure that the lower
border of the black cover is inside of the metal holder.
Information about the cabling you will find in the „appendix“ of the Options Guide
PRIMERGY RX300 S3.
To Next Page
Loading...
