Ê Remove the protective cover on the underside of the heat sink. Do not touch
the pad.
Ê Place the heat sink on the processor socket (see “Inserting the heat sink” on
page 34).
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the air duct over the main memory and the processors (see
“Inserting air duct” on page 81).
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter “Completion” on page 81.
6.3 Replacing the processor heat sink
Ê Open the server as described in section “Opening the server” on page 22.
Ê Remove the air duct over the main memory and the processors (see
“Removing the air duct” on page 22).
Ê Loosen the four heat sink screws in a crossover pattern (see section
“Replacing the processor” on page 36).
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê Remove the protective cover from the new heat sink.
Ê Place the heat sink on the processor socket (see section “Replacing the
processor” on page 36).
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the air duct over the main memory and the processors (see
“Inserting air duct” on page 81).
To Next Page
Loading...
