RX300 S4 Options Guide 69
SAS controller Upgrading a SAS controller
Figure 53: Inserting controller
Ê Install the controller in the PCI slot 1 and press it carefully down.
Ê Fasten the slot cover with a screw.
Ê Connect plug X1 up and plug X2 down on the controller.
Ê Insert the air duct, see “Inserting air duct” on page 81.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter “Completion” on page 81.
X1
X2
To Next Page
Loading...
