88 Operating Manual RX600 S6
CSS components
© cognitas. Gesellschft für Technik-Dokumentation mbH 2011 Pfad: C:\Programme\FCT\tim_app\tim_local\work\PICHOL\OBJ_DOKU-11942-001.fm
8.1.1.1 Replacing a hot-plug power supply unit
Figure 14: Unlocking and removing the power supply unit
V CAUTION!
When replacing a non-defective hot-plug power supply unit in a non-
redundant configuration, the server must be switched off first.
Ê Remove the power cord from the cable clamp. You can losen the cable
clamp by opening the small locking lever.
Ê Remove the power cord from the installed power supply unit.
Ê Press the green release lever (1) and pull out the power supply unit in the
direction of the arrow (2). Grip the handle while pulling the power supply.
V CAUTION!
Release your hands from lever (1) as soon as the power supply unit
has been pulled out a few centimeters.
Ê Completely remove the defective power supply unit from the slot.
V CAUTION!
Never leave the slot for the power supply unit empty for more than
two minutes during operation. Otherwise, excessive temperatures
could damage system components.
/
0
To Next Page
Loading...
