TX150 S6 Service Supplement 17
4 Replacement routines
V CAUTION!
Observe the safety instructions in the chapter “Safety notes” on page 11
et seq. .
4.1 Preparation
4.1.1 Floorstand model
I You will find a detailed description of “Opening the server“ and
“Removing the front cover“ in the Options Guide TX150 S6.
4.1.1.1 Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
switch for at least four seconds (“Power override“ function).
Ê Pull all power connectors out of the power outlets.
Ê If required, remove the lock on the side cover.
Ê Unlock the server.
Ê Loosen the two knurled screws at the server’s rear side.
Ê Push back the left-hand side cover approxiate 2 cm.
Ê Remove the left-hand side cover.
4.1.1.2 Removing the front cover
Remove the front cover when making the following replacements:
– Replacing the operating panel
– Replacing the DVD/DVD-RW drive
– Replacing the intrusion switches
Ê Push the drive cover up as far as possible.
Ê Remove the hard disk cover.
To Next Page
Loading...
Need help?
General