EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S7 - Page 114

Fujitsu PRIMERGY TX150 S7
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
114 Operating Manual TX150 S7
Appendix: server specification
Onboard or integrated controllers
Slots
Service LAN (RJ45) 1 x dedicated service LAN port for iRMC S2 (10/100
Mbit/s) Service LAN traffic can be switched to shared
onboard Gbit LAN port
RAID Controller Modular RAID 0/1 controller with "Integrated
Mirroring Enhanced" (SAS IME) for SAS1.0.
RAID levels 0, 1 and 1E are supported for internal
hard disk drive configurations.
Modular RAID 0/1 controller with “MegaRAID
functionality” (SAS MegaRAID) for SAS2.0.
RAID levels 0, 1,10 and 1E are supported for internal
hard disk drive configurations.
Modular RAID 5/6 controller with "MegaRAID
functionality" (SAS MegaRAID) for SAS1.0 and
SAS2.0. RAID levels 0, 1, 10, 1E, 5, 50, 6 and 60 are
supported for internal hard disk drive configurations.
SATA Controller A 6-port SATA controller is integrated on the system
board; up to four SATA hard disk drives can be
connected to the controller. The LSI Embedded
MegaRAID software (SATA Software RAID)
supports RAID levels 0, 1 and 10.
Remote Management
Controller
Integrated Remote Management Controller (iRMC
S2, 32 MB attached memory incl. graphics
controller), IPMI 2.0 compatible
Trusted Platform
Module (TPM)
Infineon / 1.2 (option)
PCI-Express Gen2 x1 2 x
PCI-Express Gen2 x4 1 x Low profile ready, full height, long 3,3 V
PCI-Express Gen2 x8 2 x short 3,3V
PCI 1 x PCI 32/33 MHz, 1x long, 5V
Slot notes in SAS configuration 1x PCI-Express occupied by
modular RAID controller

Table of Contents

Related product manuals