TX150 S7 Operating Manual 69
Starting up and operation Control elements and indicators
LAN indicators
Figure 17: Indicators on the connector panel: LAN indicators
I Depending on the settings in the BIOS, the system LAN connector may
also be used as a service LAN connector. You will find further information
in the "D2759 BIOS Setup Utility for PRIMERGY TX150 S7" manual.
1LAN
link/transfer
(service LAN)
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
2 LAN speed
(service LAN)
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
3LAN
link/transfer
(system LAN)
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
4 LAN speed
(system LAN)
Steady yellow signal in the event of a LAN transfer rate
of 1 Gbit/s
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
/
10 2
To Next Page
Loading...
