Fujitsu PRIMERGY - Page 39

9
E
2) WhenthesettingvalueintheSCSISelectutilityischanged,amessage"Save
ChangeMade?"isdisplayed.Tosaveit,movethecursorto[Yes].Toabandonit,
movethecursorto[No].Then,pressthe[Enter]key.Finally,press[Esc]key.
(Ifthesettingvalueisnotchanged,amessage"SaveChangeMade?"isnot
displayed.)
3) When"ExitUtility?"isdisplayed,movethecursorto[Yes]andpressthe[Enter]
key.
4) If"Pleasepressanykeytoreboot"isdisplayed,pressanykey.
5) TheSERVERisrebooted.
Note
IfthesettingvalueintheSCSISelectutilityischanged,thechangedvalueis
noteffectiveunlesstheSERVERisrebooted.