Fujitsu PRIMERGY - BIOS Error Messages

21
E
4.2BIOSErrorMessages
IfHostAdapterBIOSisenabled,butcannotbeinitialized,thesystemdisplaysan
errormessageafterthemessage"BIOSInstallationFailure."Examplesand
meaningsoftheseerrormessagesaregivenbelow:
Device connected, but not ready.
Thismessageisdisplayedifoneofthechannelsdoesnotreceivearesponsewhenthis
cardrequestsdatafromaninstalledSCSIdevice.Trysettingthe｢SendStartUnit
Command｣oftheSCSISelectutilityto｢yes｣.
Ifthemessageisstilldisplayed,followthediskdrivemanufacturer'sinstructionsand
setthedrivetorotatewhenthepowerswitchisON.
Start unit request failed.
BIOScannotsendaStartUnitcommandtoadevice.RuntheSCSISelectutilityand
｢no｣｢SendStartUnitCommand｣forthatdevice.
Time-out failure during ....
Anunexpectedtime-outoccurred.ChecktheSCSIbustermination.Disconnectthe
SCSIcablefromthiscardandstarttheSERVER.IftheSERVERrestartswithout
anyproblem,checkthattheSCSIbusterminatorandcablesareproperlyconnected.
OneofthedevicesorcablesontheSCSIbusmightbethecauseofthefailure.