Fujitsu PRIMERGY - Configuration; SERVER Configuration

7
E
3.Configuration
3.1SERVERConfiguration
IfSERVERdoesnotrecognizethiscardafterthiscardhasbeeninstalled,runthe
SERVERBIOSsetuputilityandcheckthePCIconfigurationparameters.Usually,
youcandothisbypressingspecifiedkeycombinationswhenyourSERVERis
booting.ThefollowingdescribeshowtoruntheBIOSsetuputility:
Note
SomeSERVERoptionsarevalidforpredeterminedPCIbusslotsonly.To
changeanoption,besureyousetoptionsforthePCIslotsinwhichthiscard
havebeeninstalled.Ifyoudonotknowwhichslotcorrespondstowhich
number,refertotheSERVER'sdocumentation.
・ IfthereisanInterruptTypeorInterruptLineoptionintheBIOSsetuputility
fortheSERVER,checktoseeifInt-AorInterruptType=Ahasalreadybeen
chosen.Changethejumpersettingofthemotherboardifrequired.
・ IfthereisaTriggeringInterruptoption,choose｢Level｣.
・ IfthereisanoptiontoenableordisablethebusmasteringfunctionofthePCI
slot,besuretochoose｢Enabled｣.
・ IfthereisanoptiontoenableordisableindividualPCIslots,setPCIslotsin
whichthiscardhavebeeninstalledto｢Enabled｣.
・ WhenanISA/EISAboardandPCIboardareusedincombination,reservethe
resourcesoftheISA/EISAboardandensurethatthesystemBIOSdoesnot
assigntheseIRQstootherPCIboards.
・ BesurethatBIOSallocatesvalidIRQsforthePCIboard,andassignthese
IRQsmanually.