2. Installation
2.1 s3-0801/1601 Switch Connectivity
The s3-0801/1601 switching system transmits keyboard, video and mouse (KVM)
information between an operator and target devices attached to the switch.
2.2 Installation Overview
The general procedure for setting up and installing a switch is as follows:
• Unpack the switch and verify that all components are present and in good
condition.
• Make all hardware connections between the power source, switch and target
devices
• Turn on the power and verify that all connections are working.
• Configure the switch’s IP address using the On-Screen Display (OSD) or On-
board Web Interface (OBWI).
Figure 2.1 illustrates a basic configuration for the s3-0801/1601 switch with
descriptions in the table following the figure.
590-1035-640A
3
To Next Page
Loading...
