ATTENTION
When inserting the documents, insert them at least 10 mm (0.39 in.) apart from each other. If the
space between the documents is less than 10 mm (0.39 in.), the scanned images may not be
cropped correctly.
a The document is pulled in until it is set inside the ScanSnap.
ATTENTION
l When you perform scanning with the output guide closed, leave enough space at the back of
the ScanSnap to allow the document to be completely ejected. In addition, when you scan
long page documents, hold the scanned documents with your hands to prevent them from
falling off the unit where the ScanSnap is placed on.
Make sure that the area where the document exits the scanner is clear of any obstacles.
Otherwise, paper jam may occur.
l If you scan the following documents with the output guide open, a paper jam may occur and
damage the documents. Scan the following documents with the output guide closed.
- Thick paper (80 g/m
2
[20 lb] or heavier)
- Postcards
- Business cards
3. Press the [Scan/Stop] button on the ScanSnap to start scanning.
ATTENTION
Do not perform the following operations during scanning. Doing so will stop scanning.
l Connect or disconnect the ScanSnap and other USB devices.
l Close the feed guide.
Scanning Documents with iX100
252
To Next Page
Loading...
Need help?
General
Weight and Dimensions
