Installing the Software from the [ScanSnap Setup] Window
Once the software is uninstalled or the installation information is removed, install the software from
the [ScanSnap Setup] window.
Install the software in the following procedure.
1. Restart the computer.
2. Log on as a user with Administrator privileges.
3. If anti-virus software is running, disable the software temporarily.
ATTENTION
If you cannot disable the anti-virus software, check if the software is set to lock the application.
4. Install the software.
For details, refer to "How to Install the Software" (page 41).
If you did not perform the procedure in "Removing the Installation Information" (page 100) and then failed to install
the software, perform the following procedures again:
l "Uninstalling the Software" (page 99)
l "Removing the Installation Information" (page 100)
l "Installing the Software from the [ScanSnap Setup] Window" (page 104)
If you still could not reinstall the software after performing the above procedures, proceed to "Installing One
Software at a Time" (page 105).
If You Have Installed the Software Before
104
To Next Page
Loading...
