16. Check the IP address of the TFTP server in the TFTP Address field.
The value that you configured using the Configuration Wizard is dis-
played as the default.
If you want to change the TFTP address, click Change TFTP
Address.
The Change TFTP Address dialog box opens.
Enter the IP address of the TFTP server you want to use.
Click OK to confirm your changes.
17. If the table contains more than one management blade or connection
blade, repeat steps 15-16 for each individual management blade or con-
nection blade.
18. Click Next. The Schedule Job step opens.
19. Specify the time at which the job is to be transferred to the servers in
the Transfer Time field.
20. Specify the time at which the update phase is to be started on the
servers in the Flash Time field.
21. Only for updates that require a reboot of the system
(indicated by Reboot = yes):
Enter the time at which the servers are to be rebooted in the Boot Time
field.
22. Click Finish to create the new job.
6.1.7.2 Copying a job
You use this procedure to copy a job to selected servers.
1. On the Job Details tab, select the job that you want to copy, see "Job
Details tab" on page 71.
2. Select Copy Job. The Copy Job wizard opens with the first step
Choose Server.
ServerView Update Management 205
6.1 Update Manager
To Next Page
Loading...