Fujitsu SPARC Enterprise M3000 Installation Guide

1-2 SPARC Enterprise M3000 Server Installation Guide • January 2009
From the operator panel, power on the server. Confirm the configuration and
operation with the dual power feed option.
Section 3.5, “Powering On the Server” on page 3-10
Connect additional peripheral devices.
Section 3.6, “Connecting Additional Peripheral Devices” on page 3-13
Test environment
creation and
confirmation of
operation
Connect the Gigabit Ethernet port (GbE port) and the user network.
Section 4.2, “Connecting to the Network” on page 4-2
Confirm the network connection.
Section 4.3, “Verifying the Network Connection” on page 4-3
Start the Solaris
TM
operating system.
Section 4.4, “Starting the Solaris Operating System” on page 4-3
Start SunVTS, and confirm hardware operation.
Section 4.5, “Verifying Operation by Running SunVTS” on page 4-4
From this point, begin to do the setup required for system operation.
Refer to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
Administration Guide.
FIGURE 1-1 Installation Workflow (Continued)
Installation Stage Workflow Task

Fujitsu SPARC Enterprise M3000 Specifications

General

Brand	Fujitsu
Model	SPARC Enterprise M3000
Category	Server
Language	English