Fujitsu SPARC Enterprise M3000

Chapter 3 Installing the Server 3-9
b. Keep it in that state for at least 5 seconds.
c. Return the mode switch to Service, and press the RETURN key.
Note – If the mode switch operation is not performed within one minute, the login
certification will expire.
8. Confirm that the XSCF Shell prompt is displayed on the administration
console.
3.4.2 Initializing the XSCF Unit
You must make various settings to use the full XSCF functionality. This section
explains how to make the required settings for installation only.
1. Make only the required settings.
For details on the setting procedure, refer to the SPARC Enterprise
M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s Guide.
The following settings are required:
■ Registration of an XSCF user account and password and user privileges (adduser,
password, setprivileges)
■ User account of a field engineer (FE) (for maintenance)
■ Date and time settings (setdate, settimezone)
■ Confirmation of the XSCF host public key (showssh)
■ SSH/telnet settings (setssh, settelnet)
■ Network interface, routing, and DNS-related settings
(setnetwork, setroute, setnameserver, etc.)
■ Advanced setting (setaltitude)
■ Dual power feed option setting (setdualpowerfeed)
Leave it in that position for at least 5 seconds.
Change the panel mode switch to Service, and press return...
XSCF>