EN
4
2 - Special Warnings
IMPORTANT INSTRUCTION
Please read all instructions before using this appliance.
Proper installation is your responsibility. Have
a qualified technician install this range.
IMPORTANT
- Observe all governing codes and
ordinances.
- Write down the model and serial numbers
before installing the range. Both numbers
are on the serial rating plate refer to the
illustration below.
LOCATION OF RATING PLATE
Before Starting Installation
• Check location where range will be
installed. The location should be away from
strong drafty areas, such as windows, doors
and strong heating vents or fans.
• Electrical grounding is required. See
“Electrical Requirements”
NOTE: This range is manufactured for use with
Natural gas or Propane.
To convert to LP (propane) or NG
(natural gas), see instructions in the
gas conversion kit provided in the
literature package. Proper gas supply
connection must be available. See gas
supply requirements.
WARNING
Before connecting the appliance to the gas
supply line, ensure that its gas setting is
appropriate.
The type of gas adjusted and shipped from
the factory is indicated on the rating plate.
IMPORTANT: Save these instructions for the local electrical
inspector use.
INSTALLER: Please leave this manual with owner for future
reference.
OWNER: Please keep this manual for future reference.
Pay attention to these symbols present in this
manual:
DANGER
You can be killed or seriously injured if you don’t
IMMEDIATELY follow instructions.
WARNING
This is the safety alert symbol. This symbol alerts you to
potential hazards that can kill or hurt you and others. You
can be killed or seriously injured if you don’t follow these
instructions.
READ AND SAVE THESE INSTRUCTIONS.
To installer:
Leave these instructions with the appliance.
To customer:
Retain these instructions for future reference.
To Next Page
Loading...
