9.CONNECTION SCHEMATICS
Pressure
sensor
Temperature
sensor
Power
input
24Vac/dc
+
-
Type 2
connector
Type 2 connector
0-10 Vdc
Type 1 connector
Type 1 connector
Insulated
port
Type 1 connector
Charge
supply
Type 1 connector: For type 1 (5.0mm) connectors,
use a Philips #1 or flat 3.0mm Screwdriver. Do not
exceed the maximum torque of 5,0 Nm.
Type 2 connector: For type 2 connectors (3.5mm)
use a Philips #0 or flat 2.4mm Screwdriver. Do not
exceed the maximum torque of 2.0 Nm.
The C and GND signals are
connected internally except
for the isolated RS485-2 port.
Relays
SSRs - Solid
State Relays
* *
*
RS485-1 RS485-2 EXP
Note: You can install up to 6 sensors configurable between temperature and pressure depending on the installation.
8
To Next Page
Loading...
