Funkwerk TRT800 - 2.2 ON;OFF; 2.3 Display-Indications

TRT800 / P/N 800ATC-(200)-(200)
Operation and Installation
10 Document-No: 03.2102.010.71e / Revision: 2.02
2.2 ON/OFF
Switch ON: press button for 0.5 s
Switch OFF:
press button for 3 s
After turning-on the display appears as follows:
(Example)
Device Name
Software-Version
Firmware-Version
If more than one aircraft address/FID exist, select the correct entry with
the rotary knob and confirm with
. If there is no external memory
(TRT800EM) connected or no 24bit address defined (000000) the
message “CRADLE OFF” appears and the transponder is not working as
Mode-S device but as Mode A-C transponder.
The transponder starts in standby mode (see section 2.5).
2.3 Display-Indications