3. PLOTTER OPERATION
3-33
3.8.3 Erasing waypoints
Erasing a waypoint directly from the plotter display
1. Operate the trackball to place the cursor on the waypoint you want to erase.
A flashing diamond mark appears over the waypoint when the waypoint is
correctly selected.
2. Press the [CLEAR] key. You are asked if you are sure to erase the waypoint.
3. Push the [ENTER] knob. The waypoint is erased from the plotter screen and
the waypoint list.
Erasing a waypoint from the menu
1. Press the [MENU] key followed by the WAYPOINTS/ROUTES and
WAYPOINTS soft key to open the waypoint menu.
2. Press the WAYPOINT BY CURSOR soft key.
3. Operate the trackball to place the cursor on the waypoint which you want to
erase. A flashing diamond mark appears on the waypoint when it is correctly
selected.
4. Press the EDIT/MOVE soft key followed by the ERASE WPT soft key. You
are asked if you are sure to erase the waypoint.
5. Push the [ENTER] knob to erase the waypoint.
6. Press the [MENU] key to close the menu. The waypoint is erased from the
plotter screen and the waypoint list.
Erasing a waypoint from the waypoint list
1. Press the [MENU] key to open the menu.
2. Press the WAYPOINTS/ROUTES and WAYPOINTS soft keys.
3. Press the LOCAL LIST or ALPHANUMERIC LIST soft key.
4. Use the trackball to select the waypoint you want to erase.
5. Press the ERASE WPT soft key. You are asked if you are sure to erase the
waypoint.
6. Push the [ENTER] knob. The waypoint is erased from both the waypoint list
and the plotter screen (if it is currently displayed).
7. Press the [MENU] key to close the menu.
To Next Page
Loading...
Need help?
General
