2. WIRING
2-12
Wire crimping procedure
1. Strip the vinyl sheath of the wire to expose the core by 3.5 mm.
2. Hold the crimping tool horizontally and insert the contact pin, with its slit faced downward,
into the crimp hole of the crimping tool.
3. From the same side, place the wire onto the contact pin and squeeze the handle until
the ratchet is released. Pull the wire to make sure that it is securely crimped.
How to use the crimping tool
Inserting contact pin into connector housing
The wires fitted with contact pins should be inserted into the connector housing referring to
the drawing below or the interconnection diagram at the back of this manual.
Note: 1. Wire differentiation
Number of dot mark (s) (1 to 4)
Dot mark color (B: Black, R: Red)
Sheath color
2. BRN and GRN show the following colors.
BRN: Light brown
GRN: Light green
3. Cover plate is not fitted to the connector.
BRN
B 1
BRN
B1
BRN
R1
YEL
B1
YEL
R1
GRN
B1
GRY
B1
WHT
B1
BRN
B2
BRN
B4
GRN
R1
GRY
R1
WHT
R1
BRN
R2
YEL
B2
YEL
R2
GRN
B2
GRN
R2
GRY
B2
WHT
R2
GRY
R2
WHT
B2
BRN
B3
BRN
R3
YEL
B3
YEL
R3
GRN
B3
GRY
B3
WHT
B3
BRN
R4
YEL
B4
GRN
R3
GRY
R3
WHT
R3
GRY
B4
YEL
R4
GRN
R4
B4
GRN
GRY
R4
T
T
S
S
R
R
P
P
J
J
K
K
L
L
M
M
N
N
D
D
E
E
F
F
H
H
A
A
B
B
C
C
Z
X
Y
VW
RS
T
U
L
M
N
P
E
F
H
J
K
A
B
C
D
Inserting pins contact
To Next Page
Loading...
