3. ADJUSTMENT
3-5
SHIP’S SPD/BR
Choose the source of speed and course data with which to draw ship’s track.
1. Rotate the [RANGE] control to select SHIP’S SPD/BR.
2. Rotate the [GAIN] control to choose item appropriately.
LOG GYRO: Use data from the speed log connected to LOG port as ship’s speed, data
from gyrocompass connected to GYRO port as ship’s course.
CURRENT: Use data from the current indicator connected to NMEA1/CIF1 or
NMEA2/CIF2 port.
NAV DATA: Use data from the GPS navaid connected to NMEA/CIF 1 or NMEA/CIF 2 port.
GYRO+NAV: Use heading data signal from the sensor connected to the GYRO port for
course, data from the GPS navaid or current indicator connected to NMEA/CIF
1 or NMEA/CIF 2 port for the ship’s speed. When using data from the current
indicator (for positioning) for ship’s speed, set DIP switch #2-2 in the
transceiver unit to ON.
S2
S3
MAIN Board
10P6950
Location of DIP switch S2
LOG PULSE
Choose log pulse/mile specification of speed signal from the LOG port, 200 or 400
pulse/mile.
1. Rotate the [RANGE] control to select LOG PULSE.
2. Rotate the [GAIN] control to choose 200 or 400.
To Next Page
Loading...
