10
11. Confirm that the transducer is flush with the hull.
Note: Never weld the hull flange or transducer tank when the transducer is accommodated,
nor weld near the transducer of other equipment.
When the transducer 1 is replaced, or separated from the shaft 5
re-assemble as follows;
Fixing
Screws
(4)
Face C
Face D
1. Remove sealant from face C and face D.
2. Apply adhesive #1104 (Three Bond) to face
D and four fixing screws.
3. Re-assemble shaft and transducer.
To Next Page
Loading...
