1. MOUNTING
1-19
15. Fasten the gland (19) to the top of the shaft (5).
16. Apply the Liquid Gasket TB1121 to both sides of the gasket2 (18), and put it on
the ball valve (20).
17. Put the shaft on the gasket2 (18), and align the hollow side on the flange (3) with
the projection of the transducer (1).
18. Remove three M8 hex. bolts (13) and three M8 spring washers (14) from the lock
ring (6) to free the shaft (5).
19. Fasten the flange (4) loosely with the M16 hex. bolt (12), M16 nut (10) and M16
flat washer (11).
20. Insert the shaft so the projection on the transducer (1) fits in the groove on the
flange (3). Move the shaft up and down by hand to confirm that it moves smoothly.
Gland (19)
Flat washer (8)
Gasket (7)
Flat washer (8)
The projection on the transducer (1)
Flange (4)
Hex. nut (15)(M4x16)
Seal washer (16)(M4)
Apply Liquid Gasket (TB1121) here.
The fore mark on the shaft
Check that they
are aligned.
To Next Page
Loading...
