1. MOUNTING
1-20
21. Tighten the M16 nut (8 pcs.) on the ball valve (20).
22. Loosely fasten two sets of M8 hex. bolt (13) and M8 spring washer (14) at the top
side of the lock ring (6).
23. Fasten the M8 hex. bolt (13) tightly and the M8 spring washer (14) at the lateral
side of the lock ring (6) to fasten the shaft (5).
24. Fasten tightly two sets of M8 hex. bolt (13) and M8 spring washer (14) fastened
at step 22.
A
Hex. bolt (13)(M8x30)
Spring washer (14)(M8)
Hex. bolt (13)(M8x30)
Spring washer (14)(M8)
Hex. bolt (13)(M8x30)
Spring washer (14)(M8)
Lock ring (6)
Flange (4)
Shaft (5)
Transducer (1)
Hex. bolt (12)(M16x60)
Gasket2 (18)
(Apply the Liquid Gasket
TB1121 to both sides.)
Nut (10) (M16)
Flat washer (11)(M16)
Ball valve (20)
Flange (3)
Align the hollow side
of the spacer (3) with
the projection on the
transducer (1).
Transducer (1)
Spacer (3)
View from "A"
A
B
Hex. bolt (13)(M8x30)
Spring washer (14)(M8)
1. Fasten "A" loosely (step 22)
2. Fasten "B" tightly (step 23)
3. Fasten "A" tightly (step 24)
Hex. bolt (13)(M8x30)
Spring washer (14)(M8)
To Next Page
Loading...
