1. MOUNTING
1-3
2. Fit the cable gasket to the cable clamp, referring to the figure below.
3. Pass the cabling through the cable gasket and cable clamp.
Note: To maintain the IPX5 waterproof rating, the cable must be TTYCSLA-4 (or
equivalent) with a diameter of φ14.4±0.4 mm.
4. Fit the cover gasket to the rear of the display
unit. Make sure the cover gasket is placed in-
side the groove indicated in the figure below.
5. Connect the cabling to the display unit, referring to section 2.3.2.
6. Slide the cable clamp along the cable until the clamp is flush against the rear of
the display unit.
Note: The cable clamp must be oriented with
the dome-side up, to prevent water intrusion.
7. Fasten the four screws removed at step 1.
8. Secure the cabling to the cable clamp with cable ties (local supply) referring to the
figure in section 2.3.2.
1.1.4 How to install the display unit on a desktop or overhead
The display unit is shipped with the hanger.
1. Place the display unit on a firm, flat surface, then unfasten the two knobs on either
side of the display unit to separate the display unit and hanger.
2. Drill four holes for the self-tapping screws (φ5×20) at the installation location.
Fixing lip
Cable clamp Cable gasket
1. Fit the cable gasket to the cable clamp,
passing the fixing lip partially through
the cable clamp.
2. To pass the fixing lip completely
through the cable gasket, twist the
cable gasket gently.
3. Check that the cable gasket is flush
against the cable clamp, as shown
below.
4. Check that the cable gasket’s fixing
lip is flush against the inside of the
cable clamp.
Fixing lip
WAGO lever
Groove for
cover gasket
Groove for
cover gasket
Dome
Cable
clamp
Cable
clamp
To Next Page
Loading...
Need help?
General
