Furuno FA-40 - Specifications

FURUNO FA-40
SP - 1 E4513S01B
200127
SPECIFICATIONS OF AIS RECEIVER
FA-40
1 GENERAL
1.1 Type AIS Receiver
1.2 RX capacity 2250 report/minute, 1 channel
4500 report/minute, 2 channel
1.3 RX system Dual wave simultaneous reception
1.4 Frequency switching Automatic (manual switching available)
1.5 Initialization Within 30 seconds after power-on
1.6 Regulations IEC 62287-2, receiver standard applicable
2 AIS RECEIVER
2.1 Frequency range 156.025 MHz to 162.025 MHz (F1D)
2.2 Oscillator frequency 1
st
local oscillator: f+ (46.35/58.05 MHz),
2
nd
local oscillator: 45.9/57.6 MHz
2.3 Intermediate frequency 1
st
: 46.35/58.05 MHz, 2
nd
: 450 kHz
2.4 Receiving method Double super heterodyne
2.5 Sensitivity -107 dBm or less (PER20% or less)
2.6 Error at high input level -77 dBm (PER2% or less), -7 dBm (PER10% or less)
2.7 Co-channel rejection -10 dB or more
2.8 Adjacent channel selectivity 70 dB or more
2.9 Spurious response 70 dB or more
2.10 Inter-modulation 65 dB or more
2.11 Sensitivity suppression 86 dB or more (±5 MHz, ±10 MHz)
3 GPS RECEIVER
3.1 Number of channel GPS: 12 channels parallel, SBAS: 2 channels, 14 satellites
3.2 Receiving frequency 1575.42 MHz, C/A code
3.3 Position accuracy GPS: 13 m approx. (2drms, HDOP<4)
3.4 Tracking velocity 1000 kn
3.5 Position fixing time 90 s approx.
3.6 Update interval 1 s
3.7 DGPS data correcting By AIS information
4 INTERFACE
4.1 Number of port
Serial 2 ports, IEC61162-1, 4800/38400 bps
NMEA2000 1 port, External power required 12-24 VDC (9-32 V),
LEN=1@9V
USB 1 port, USB2.0, Full speed, for maintenance
4.2 Data sentence
Input ACA, ACK, AIQ, DTM, GBS, GGA, GLL, GNS, HDT, OSD, RMC,
SSD, THS, VBW, VSD, VTG
Output ABK, ACA, ACS, ALR, GGA, GLL, RMC, SSD, TXT, VDM, VDO,
VER, VSD, VTG