4. WAYPOINT
4-4
4.1.3 Entering a waypoint/MOB mark with an external event switch
If the equipment is equipped with an external event switch you may choose what mark
is inscribed on the screen when the switch is pressed. The choices are Waypoint,
MOB mark or Off (no event switch is connected).
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose ADVANCED from the menu bar and then
push the [ENTER] knob.
3. Rotate the [ENTER] knob to choose INPUT/OUTPUT and then push the [ENTER]
knob.
4. Rotate the [ENTER] knob to choose EXTERNAL EVENT and then push the
[ENTER] knob.
5. Choose Off, WPT or MOB as appropriate and then push the [ENTER] knob.
6. Press the [MENU] key to close the menu.
Off
WPT
MOB
www.reelschematic.com
www.reelschematic.com
To Next Page
Loading...
