6. NAVIGATION
6-12
6.5 Affecting the Destination Set at Primary Unit to
Secondary
When multiple GP-7000 series plotters are connected, the C-LINK feature may be ac-
tivated to duplicate at the secondary plotter the destination set at the primary plotter.
With C-LINK not turned Off, destination may also only be set at the primary plotter.
As for secondary units, a "mirror chart card" which mirrors the same area data in the
C-MAP MAX chart card in the primary unit, is available. This economical card can be
obtained from your dealer.
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose ADVANCED from the menu bar and then
push the [ENTER] knob.
3. Rotate the [ENTER] knob to choose INPUT/OUTPUT and then push the [ENTER]
knob.
4. Rotate the [ENTER] knob to choose C-LINK and then push the [ENTER] knob.
5. Choose Secondary Station, Primary Station or Off as appropriate and then push
the [ENTER] knob.
Secondary Station: This unit is designated as the secondary plotter. Destination
cannot be set or changed from the secondary plotter.
Primary Station: This unit is designated as the primary plotter.
Off: C-link feature is turned off.
When multiple units are installed, designate only one unit as the primary plotter.
All other units should be designated as secondary stations.
6. Press the [MENU] key to close the menu.
Note: If two or more GP-7000 series plotters are set as primary, the message "Both
chart plotters are set as Primary station." appears with audible alarm.
Secondary Station
Primary Station
Off
www.reelschematic.com
www.reelschematic.com
To Next Page
Loading...
