6. NAVIGATION
6-11
Skipping route waypoints
In some instances you may want to "skip" waypoints while following a route. In the fig-
ure below, for example, the vessel has decided to navigate from waypoint 05 to 03,
skipping waypoint 04.
1. Press the cursor pad to place the cursor on a waypoint which is part of the route.
2. Press the ROUTE LIST soft key to show the route list.
3. Press the cursor pad to choose a route.
4. Rotate the [ENTER] knob to choose EDIT at the bottom of screen and then push
the [ENTER] knob.
The route menu appears.
5. Press the cursor pad (S T) to choose the waypoint you want to skip.
6. Press the SKIP soft key.
7. Press the SAVE soft key to close the route menu.
8. Press the [CLEAR] key to close the route list.
6.4 Cancelling Navigation
1. Press the [TLL/GOTO] key.
The confirmation window appears.
2. Confirm that "STOP" is selected, and then push the [ENTER] knob.
The navigation is cancelled.
PORT 1
PORT 2
Waypoint 1
Waypoint 2
Waypoint 3
Waypoint
To Next Page
Loading...
