Furuno TZT16F - Wiring; Interface Connections (Rear of Unit)

2-1
2. WIRING
2.1 Interface Connections (Rear of Unit)
USB1USB1
USB2
microB
USB2
microB
HDMI
IN/OUT
HDMI
IN/OUT
DI-FFAMPDI-FFAMP
Rear of TZT16FRear of TZT16F
EMI
Core
Ground wire
(Local supply,
IV-8sq.)*
1
Power Cable
FRU-3P-FF-A002M-
001
䠄
2 m, supplied)
Transducer Cable
*2
TO: Transducer or to
Fish Finder Power
Amplifier DI-FFAMP
TO: Ship ’ s ground
NETWORK1/2NETWORK1/2
NMEA2000NMEA2000
MULTI cableMULTI cable
VIDEO-IN 1/2VIDEO-IN 1/2
*
1
: Lay the ground wire away from this unit’s power cable.
*
2
: Use of the extension cable (C332 10M) may cause the following problems:
- Reduced detection ability
- Wrong ACCU-FISH™ information (fish length smaller than actual length, fewer fish
detections, error in individual fish detection).
- Wrong speed data
- No TD-ID recognition
*
3
: Depending on the transducer type, 12-10P Conversion cable is not required.
TO:
12 to 24 VDC
12-10P
Conversion Cable
FRU-CCB12-MJ-01
(0.4m, supplied)
*3