EasyManua.ls Logo

Furuno TZT16F - Plotter Display; Data Area Overview; Switching 2 D and 3 D Views; Orientation Modes

Furuno TZT16F
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
i
SAFETY INSTRUCTIONS
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
WARNING
CAUTION
Warning, Caution Prohibitive Action Mandatory Action
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment
unless totally familiar with
electrical circuits.
Only qualified personnel should
work inside the equipment.
Turn off the power at the
switchboard before beginning
the installation.
Fire or electrical shock can result
if the power is left on.
CAUTION
Be sure that the power supply is
compatible with the voltage
rating of the equipment.
Connection of an incorrect power
supply can cause fire or damage
the equipment.
Use the proper fuse.
Use of an incorrect fuse may
damage the equipment.
The front panel is made of glass.
Handle it with care.
Injury can result if the glass breaks.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
TZT16F
Steering
compass
0.70 m
0.45 m
(Examples of symbols)
Model
Ground the equipment to prevent
electrical shock and mutual interference.
If your vessel is configured with
an autopilot system, install an
autopilot control unit (or emer-
gency autopilot stop button) at
each helm station, to allow you
to disable the autopilot in an
emergency.
If the autopilot cannot be disabled,
accidents may result.

Other manuals for Furuno TZT16F

Related product manuals