Furuno TZT16F - How to Set up the Equipment

3-1
3. HOW TO SET UP THE
EQUIPMENT
This chapter shows you how to set up your system according to the equipment you
have connected.
Touch control description
The touch control depends on the screen type. The basic operations to use during the
installation setup are in the following table.
How to operate the menus
The following procedure shows how to use the menu system.
1. Tap (power switch) to turn the power on.
2. After the startup process completes, the last used display appears and a warning
message is displayed. After reading the message, tap [OK].
3. Tap the [Home] icon ( ) to show the home screen and display mode
settings.
4. Tap [Settings] to open the [Settings] menu.
Operating by a finger Function
Tap • Select a menu item.
• Select a setting option where
there are multiple options.
• Select an object.
• Display the pop-up menu
where available.
Drag • Scroll the menu.
Pinch Change the Fishfinder, plotter
and radar range.
Zoom in Zoom out
Home menu
D
is
p
l
a
y
Mode
S
e
tt
in
g
s
Display Mode Setting
s
Display Mode Setting
s