52
Changing wheel position
Modifying for left-hand use
1. Connect the wheel unit wiring harness
through the offset adapter. Install the adapter
using four 2.5mm hex bolts attached.
2. Reinstall the wheel unit, wheel unit
cover, wheel, and wheel cap in same
position as they were removed.
1. Remove the wheel back cover using
2.5mm hex wrench.
2. Push the wheel unit wiring harness in the
opposite side.
3. In opposite side, connect the wheel unit
wiring harness and reinstall the wheel unit,
wheel unit cover, wheel, and wheel cap in
the same position as they were removed.
To Next Page
Loading...
