FUTABA 3PM - Frequency Selection (T3 PM-FS only); Model Copy; CPY

52
Functions
Model Reset / CLR
This functions resets the contents of the currently called model memory to the initial
value. However, it does not reset the lap time memory, HRS/PPM select, and LED
mode selection.
Model Reset
1 (Reset execution)
Press the (+) and (-) buttons simultaneously for about 1 second.
2 When ending adjustment, once turn off the power switch before use.
Current model No.
Calling the setup screen
1. Turn on the power switch
while pressing "SEL" key.
2. Next, use "SEL" key to select
the desired function screen.
Model Name / NAM
This function allows you to assign a three character name to each model memory.
(Number and alphabet can be used.)
Model Name
1 Move the cursor (blinking) to the column you want to change using the
(CH) button.
2 Change the character using the (+) or (-) button.
(Set the model name by repeating steps 1 and 2 above. )
3 When ending adjustment, turn off the power switch before use.
Model name
Calling the setup screen
1. Turn on the power switch
while pressing "SEL" key.
2. Next, use "SEL" key to select
the desired function screen.