16
ADJUSTING THE IENGTH OF THE CONTROL STICKS
springs, you’ll have to remove the rear case of the transmitter. First, remove the battery cover on the rear
of the transmitter. Next, unplug the battery wire, and remove the battery from the transmitter. Next, using a
screwdriver, remove the four screws that hold the transmitter’s rear cover in position, and put them in a safe
Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension.
The tension
increases
when the adjusting screw is turned clockwise. When you are satisfied with the
spring tensions, reattach the transmitter's rear cover. When the cover is properly in place, reinstall and tighten
the four screws. Reinstall the battery and cover.
transmitter more comfortable to hold and operate. To lengthen or
locking piece B and turning stick tip A counterclockwise. Next, move
the locking piece B up or down (to lengthen or shorten). When the
length feels comfortable, lock the position by turning locking piece B
counterclockwise.
Stick tip A Locking piece B
Stick lever tension adjustment
Mode 2 transmitter with rear case removed.
Aileron
Elevator
Rudder
Stick Stick
Four screws are
removed and rear
case is removed.
ADJUSTING DISPLAY CONTRAST
To adjust the display contrast, from the home menu press and hold the END BUTTON.
Push the
＋−
KEY while still holding the END BUTTON:
＋
KEY to brighten
−
KEY to darken the display
screw is clockwise.
tick tension ma im m tick tension minim m
screw is co nter clockwise.
screw is kept
rom coming o t
rom a line.
※Ascrewtouchesacase.
To Next Page
Loading...
