43
Auxiliary channel function (
AUX-CH
Adjustability:
SWITCH (A-H), TRIM LEVER (DT5
and DT6), or KNOB [VR].
channels for 2 rudder servos.)
GYRO SENSE
,
GOVERNOR
, and
THR-NEEDLE
functions are activated,
AUX-CH
settings of related channels become invalid automatically.
Related channels:
GYRO SENSE
(
ACRO
/
HELI
): ch. 5, 7, or 8: see p. 64 and p. 87
GOVERNOR
(
HELI
): ch. 7, or ch. 7 and 8: see p. 89.
THR-NEEDLE
(
ACRO
/
HELI
): ch. 8: see p. 62.
GOAL of EXAMPLE: STEPS: INPUTS:
Assign flaps to the digital trim [DT5]
and set channel 7 to
NULL
in preparation
Open
AUX-CH
function.
for 1 second.
to
AUX-CH
.
Choose the channel to change. (ex: ch.
6.)
to
Ch 6
.
Change primary control. (ex: to digital
trim [DT5].)
to
DT5
.
Repeat as needed. (ex: ch. 7 to
NULL
.)
to
Ch 7
. to
NULL
.
Close.
Where next? Programmable mixes: see p. 65.
Set up dual/triple rates and exponential (
D/R
,
EXP
): see p. 39.
Adjust
SUB-TRIM
of auxiliary channel to adjust center SWITCH position:
see p. 46.
Adjust
END POINTs
(sets end points of travel even when using a switch):
see p. 36.
The priority of AUX
higherrank Priority lowrank
PIT
FLAPTRIM
AIL-DIFF
AILVATOR
GYRO
GYRO
WARNING
Don't assign two or more functions to one channel.
Priority may be given to a higher rank function and
a low rank function may be canceled.
SW-G
SW-F
SW-C
FLAPERON VR
GYRO
GYRO
GYRO
DT5
DT6PIT
PIT
THR→NEEDL
GOVERNOR
THR→NEEDL GYRO GOVERNOR VRELE2
To Next Page
Loading...
