FUTABA 8J - Transmitter Settings Configuration; Transmitter Stick Modes; Stick Calibration (STK-ADJ)

91
TX SETTING


■ STK-MODE
■ STK-ADJ(calibration)
The transmitter may be operated in four different


         
         
       
        


The mode can be chosen by
＋−
KEY from "STK-
MODE" of the TX SETTING screen. The throttle detent
mechanism will have to be moved as well. This can be

Usually, this calibration is unnecessary.
 
prolonged use.
THRELE
RUD
AIL
MODE1
ELETHR
RUD
AIL
MODE2
THRELE
AIL
RUD
MODE3
ELETHR
AIL
RUD
MODE4
①
Simultaneously depress the
＋
and
−
keys, and then turn
on the power.
②
It is down about


KEY. It chooses
STK-
ADJ ＞ NEXT
③
 is pushed.
Thecallofasettingscreen
＋ −
＋ −
①
       
＋−
Keys.
②
It is down about


KEY. It is set to
ADJ ＞ NEUT
■
③

and  is
pushed.
calibration
23
4
1
1.
Simultaneously depress the
＋
and
−


․
−
＋